What we handle
- Light fixture installation — pendants, sconces, recessed lighting, ceiling fixtures
- Chandelier installation, including two-storey entries and high ceilings (rated boxes, proper rigging)
- Concealed LED strip lighting in built-ins, shelving, media walls and under cabinets
- EV charger installation — Tesla Wall Connector and other Level 2 chargers, dedicated circuits
- Meter bank and electrical service rebuilds for apartment buildings and older properties
- Panel upgrades, service disconnects and breaker work
- Ceiling fan installation and replacement
- Troubleshooting — dead outlets, tripping breakers, flickering lights
How it works
- 01Tell us what you need
Send photos of the space and the panel if you can. A lot of electrical scope — panel capacity, run distance, access — is visible in a picture before anyone drives out.
- 02Assessment and written estimate
Our licensed electrical partner assesses the job — panel capacity, circuit route, permit requirements — and you get one written price for the whole thing before work starts.
- 03Licensed work, managed
The licensed contractor performs the work and pulls any permit required. For meter and service work we coordinate the utility disconnect and reconnect and the inspection sequence, so the building isn't sitting dark waiting on paperwork.
- 04Test and walk it
Everything is tested in front of you — every fixture, every circuit, every label on the panel — before the job is called done.
Questions we get asked
Are you licensed electricians?
We're a general contractor, so we run the whole job. For electrical work, our licensed electrical partners do the install and we manage it end to end.
How much does it cost to install an EV charger at home?
For most Leander and Cedar Park homes with a modern 200-amp panel and the charger near the panel, the all-in figure typically lands between $900 and $2,500 including the charger. A long run across the house or a panel upgrade moves it up. We break the real numbers down in our EV charger cost guide, and you get a written estimate for your house before anything starts.
Can you hang a chandelier in a two-storey entry?
Yes. At that height it's a rigging job as much as an electrical one: the box has to be rated for the fixture's weight, the drop measured for the room rather than the ceiling, and the fixture lifted and leveled without marking the walls. Our work page shows a twenty-light chandelier we ran in a two-storey entry.
Do you replace meter banks for apartment buildings?
Yes — it's some of the most specialised work we manage. Older Austin-area buildings are increasingly required to bring meter banks up to current code, including exterior emergency disconnects, rather than patch them. We coordinate the licensed crew, the utility, and the inspection, and sequence the work so tenants aren't left without power longer than the job requires.
Who handles permits and inspections?
The licensed electrical contractor pulls the permit where one is required, and we manage the schedule around the inspection. Meter and service work also involves the utility — Austin Energy inside Austin, Pedernales Electric across much of Leander and Cedar Park — and that coordination is part of the job, not an extra.
What areas do you cover for electrical work?
Leander, Cedar Park, Georgetown, Liberty Hill, Round Rock, Pflugerville and the greater Austin area — the same footprint as the rest of our work.
Get a free estimate
Tell us about your electrical & lighting job. A photo helps. We read every request and usually reply the same day.
Read first
Straight answers on what this work costs and what actually goes wrong — written for Central Texas homes, not copied from a national template.